Thanks cheetah, youll get there for sure. Actually I’ve been at this since then end of November. If I could have devoted 50 hours a week to this It wouldn’t have taken me so long. Anyway, what I did is I used picture hanging strips made by 3M on the light fixtures and I placed the ends of the fixtures (sometimes only 1 end) inside the wiremold about a 1/4″ to hold it in place. I used the picture hanging strips cause u can remove them with no residue and I’ve used velcro in my ice cream truck and the heat causes it to fail. Even if the strips fail the fixtures are still being held in place by the wiremold except at the ends. If this is an issue I’ll install wiremold clamps on the ends of the fixtures. It should be noted that there is two sizes of wire mold conduit and I am using the larger of the two as that is what menards carries. The light fixtures are pretty thin though and I think they’d fit inside the smaller wiremold as well.Menards also carries a plastic round conduit made by wire mold and that would be much easier to cut.

Looks great KoC you have done a tremendous amount of work in such a short time it seems….and it looks great I am jealous!!!! I’ll get there some day. Question for you? are your led lights mounted on a strip or bracket or are they loose and you made a bracket for them?

Thanks