Just wanted to update my post. I got sick so that took alot of the wind out of my sails so to speak. Anyway, since my last post I installed the cove base and the switch for the exhaust fan. Placed the freezer inside and secured it to the floor, placed the prep table inside and anchored it to the wall. The prep table I am using was used so I took some time cleaning that up. I placed the griddle stand and the bottom half of the griddle inside also.( had to take the plate off to change the Natural gas orifices to the supplied LP orifices) I suppose my next is to figure out the best way to anchor the griddle stand to the floor then the griddle to the stand then route and run my gas line underneath the trailer.
Incase anyone is wondering why in the heck I have masking tape on the walls everywhere it’s because the tape represents where my wall studs are.